13pcs Harmonic Balance Puller HEAVY DUTY Shaft Steering Wheel Crank. Wiper Arm Removal Tool Bearing Arm Remover Removes. The key steps in the pitman arm removal process are. Remove the draglink using a ball joint remover device. Remove the retainer bolt. Apply grease to the face of the sector shaft and position the pitman arm puller on the center line of the sector shaft. Tighten puller bolt, a tap with a hammer on the pitman arm may be required to release the. The conventional steering box accomplishes this with a worm gear, ball nut, and sector gear and shaft housed in the steering box, and steering linkage consisting of a pitman arm, idler arm, center link, and tie-rods, which are attached to the steering knuckles/spindles where the wheels are mounted.
- Heavy Duty Steering Box Arm Removal Tool For Macbook Pro
- Heavy Duty Steering Box Arm Removal Tool For Mac Osx
- Heavy Duty Steering Box Arm Removal Tool For Mac Office
Steering systems for heavy duty trucks are made up of many components from the steering wheel to the road wheel. The purpose of the steering system is to give the driver directional control of the vehicle. When a driver feels the steering control over his/her vehicle is not like it should be, it is up to you to determine if there. Easily remove even the most stubborn pitman arms on Sheppard M100 gearboxes. Eliminates dangerous hammering and cutting torch methods. May be used with up to a 3/4″ impact tool.
Correctly and Safely removing and reinstalling a pitman arm can be more difficult than it first appears. Aside from the potential for injury reinstalling it incorrectly will impact on the performance of the steering system and the life of the components.
For instance incorrect installation can cause issues with wheel cuts on a vehicle, so it is important to get it right. The best start to getting it right is having the correct tools for the job.
Tools
There are a number of specialist tools which are recommended for the safe removal and reinstallation of the pitman arm,
Ball Joint Removal Kits – Hydrosteer Part Number 43-20245 (Large) and 43-20270 (Small)
Ball Joint Remover Kit – Small
Pitman Arm Puller – Hydrosteer Part Number J43744 or 3591842K (Multiple versions available ask our technical staff for help)
Torque Wrench
Impact Wrench 3/4″ or Larger.
The key steps in the pitman arm removal process are
Heavy Duty Steering Box Arm Removal Tool For Macbook Pro
- Remove the draglink using a ball joint remover device.
- Remove the retainer bolt.
- Apply grease to the face of the sector shaft and position the pitman arm puller on the center line of the sector shaft.
- Tighten puller bolt, a tap with a hammer on the pitman arm may be required to release the tapers.
Heavy Duty Steering Box Arm Removal Tool For Mac Osx
The key steps in the pitman arm installation process are
- Place pitman arm over the sector shaft aligning the timing marks
- Apply antiseize compound to the retainer nut
- Torque the retainer nut to the torque specified on the nut
- Continue to torque until locking tabs align with retainer nut
- Punch locking tabs into place.
The video below, from R.H. Sheppard runs through the correct removal and installation process for a pitman arm.
